Home :: Cleaning and Preparation :: Ecostrip Coating Remover

Ecostrip Coating Remover

Ecostrip Coating Remover

The Ecostrip Coating Remover is an environmentally friendly easy to use Professional grade coating remover.
This strong fast acting stripper will remove all sealers including Polyurethanes, water based stains, paints, lacquers and even Artex.
The revolutionary stripper is water based, low odour, low VOC, fast acting and extra strong. 
Simply apply the gel, leave for the required time and jet wash, scrape or scrub off the coating.
Eco Strip Coating Remover is suitable for internal or external use.


The Ecostrip is an environmentally friendly easy to use Professional grade coating remover.
This strong fast acting stripper will remove all sealers including Polyurethanes, water based stains, paints, lacquers and even Artex.
The revolutionary stripper is water based, low odour, low VOC, fast acting and extra strong. 
Simply apply the gel, leave for the required time and jet wash, scrape or scrub off the coating.
Ecostrip is suitable for internal or external use.
 
Features:
  • Water Based
  • Low Odour
  • Safer
  • Easy to apply gel
  • Fast acting
  • Can remove around 1.6 Sq Metre of paint per 1 Ltr.
Recommended Usage on these surfaces:
  • Paving bricks
  • Printed Concrete
  • Stone
  • Brick
  • Fibreglass
  • Wood
  • Metal
Useful Information:
  • Wear suitable gloves & eye protection
  • Ecostrip must be shaken well before use
  • For best results use between 10C - 30C
  • Do not try to spread the product too far as this will result in poor penetration
  • Allow Ecostrip to do its work:  do not try to remove too quickly 
  • Never let the surface become too dry during treatment
Preparation
  • Ensure surfaces to be stripped are dry.
  • Protection should be provided for floor coatings, or any surface that may be damaged by Ecostrip (perspex, plastics, rubber etc.)
How to apply
  • Cover top with a cloth during opening to avoid splashes.
  • Apply generous, even coat & do not brush out. Layer Ecostip onto surface to be stripped with suitable brush..
  • Leave for 1 hour & apply a second generous coat. For less than 5 layers of paint or varnish, a second coat may not be necessary.
  • After product has penetrated to be substrate (up to 24 hours), scrape off, leaving surface as clean as possible.
  • Rub down using a scrubbing brush or stainless steel pad & water. If working externally you can jet wash the surface off.
  • Rinse with clean cold water & allow to dry.
  • Removing Tar or Bitumen:  If you put the gel on nice and thick, cover the area with plastic so it doesn't dry out too fast. a minimum of 4 hours (ideally overnight) is required to then remove the tar or bitumen.

 

Ask us a question