AdSeal Heavy Duty Sealer
AdSeal Heavy Duty is designed as a commercial product to give a hard wearing finish and outstanding results, in heavily used areas, on unglazed natural materials such as Marble, Stone, Slate, Travetine, Terracotta, and also on Engineered stone .
A ready to use solvent based protector. Simply apply two thin coats for a delicate colour enhancing gloss and add further coat to increase the shine right up to a high gloss.
AdSeal Heavy Duty Sealer largely prevents staining and facilitates routine maintenance plus it has very little effect on the slip resistance of the surface when applied as a low sheen single coat. Subsequent coats may reduce slip resistance.
Developed by our own design team and consultant organic chemists, this fantastic product offers ease of installation with excellent performance and longevity and is ideal for use as:
- Natural Stone sealer
- Slate sealer and slate tile sealer
- Marble, limestone sealer
- Terracotta and travertine sealer
- and for most natural paving
- also engineered paving products such as Marshals, Bradstone, etc.
- Wall and floor surfaces
- Shopping Malls and public areas
- Commercial Kitchen floors
- Can be used indoors or outdoors
Durability
Indoors and lightly trafficked areas, with correct maintenance and depending upon surface type, potentially 10 years plus. Externally colour will remain for 1 – 2 years although protective effect will remain for longer, potentially 4 – 6 years, depending upon surface type.
A major design feature of this product is that it is easily re-coatable and does not need stripping before future treatment as maintenance coats cross link into original forming a monolithic layer. Down time is minimised with rapid cure additives.
Fading of the colour and reduction in protective effect take place more rapidly in heavily trafficked areas and these areas can be easily ‘touched up’ without the need to strip the original coat. Lower trafficked areas will only need retreating very occasionally, if ever.
Maintenance
Sweep regularly to remove abrasive dirt and grit from surface and mop daily using a mild detergent. Spills and marks should be wiped up as soon as possible and not allowed to dry on.
Should signs of wear appear a maintenance coat can be applied. Clean and thoroughly dry surface to be treated. Apply single ‘tight’ coat in accordance with standard application instructions. The new coat will cross link into earlier coats so there is no need to strip unless resin build up or blemishes are an issue.
