A penetrating hardener, modified with 100% polymer resin with a special surfactant for fresh and old concrete. Creates a curing membrane for uniform hardening of fresh concrete. Has a CE MARKING
Adseal NANO-LITHIUM properties are deeper penetration, faster installation and reduced reaction times but also creates a curing membrane for even hardening of fresh concrete – cannot peel or flake.
Recommended for hard and tightly trowelled concrete .
Binds loose, friable and porous mineral substrates whilst hardening structure and binding dust.
- Increases the compressive strength of the concrete by as much as 25%
- Increases abrasion resistance about 2.5 times
- Virtually all abrasion dust is eliminated
- Excellent resistance to freeze thaw cycles
- Greatly increased resistance to dirt, making cleaning and maintenance easier
- Treated area can be polished if required
-
Treatment is permanent and protects underlying substrate from
detergents, motor oil, petrol, transmission fluid, solvents, de-icing and other common chemicals
Used on paving, floors and walls including
- Concrete bridges
- Tunnels
- Walk-ways
- Retaining walls
- Hard-standings
- Car-parks
- Car washes
- Harbours
- Airports
- Factories
- Agricultural buildings
- Parking decks
- Driveways & paths
- etc..
And other high traffic areas
- Factory floors
- Storage areas
- Distribution depots
- Warehouses
- Workshops
- etc..
Suitable for use on mineral substrates such as concrete, stone and plaster and can be coloured with Adseal NANO-Colour. Use also on lime paints to convert the surface into a hard, ceramic like, coating, which, after reaction, cannot peel, or flake.
Simple and cost effective to apply. Zero VOC, non-flammable, no odour and safe to use. For use both indoors and outdoors. This product has a CE marking
DOUBLE CONCENTRATED – dilute 1 : 1 with water yields 12% solids –higher than industry standard of 8%
Dilution rates
Very hard surfaces 1 : 2 water
Hard 1 : 1
Normal 1 : 0.5
Soft Neat
Faster cure rate accepts pedestrian traffic after 1-2 hours and light vehicles after 24 hours. The most suitable hardener for polished concrete; creates a high gloss level at the surface. Recommended for hard, tightly trowelled concrete. This product has a CE marking
Application rate: Normal surface 6-8 m²/litre
[depending on porosity] Power floated surface 10-15 m²/litre
Available in 5 litre & 20 litre containers
